Web Mountain Technologies RUC-01 Guide de l'utilisateur télécharger pdf (Page 35)

Web Mountain Technologies Page 29

To setup a UPB Link as the trigger event, select UPB Link from the dropdown selection, then

either enter in the serial string command as generated by the UPB command wizard, or enter

in your desired NID, LID (Link ID), and select your command from the dropdown, as shown

below. Again, do not enter in the start character (Control-T) or the terminating character (CR).

Notice that UPB Direct Commands and UPB Link Commands are the same – the only difference

is the DID vs the LID. DIDs operate on one unit while LIDs operate on all devices associated

with that link.

To setup a Zwave command as the trigger event, select Zwave from the dropdown, then enter in

the serial string command as desired, as shown below. Do not enter in the start character (<)

or the terminating character (Carriage Return).

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 103 104

Pas de commentaire

Web Mountain Technologies RUC-01 Guide de l'utilisateur Page 35